Antique Chest Of Drawers

CHESTS OF DRAWERS: VENEERED
About 1680-1740 Walnut
The art of veneering was introduced to England by Dutch and Flemish craftsmen working in and around London during the Restoration period.
Generally three long drawers below two short. Most with over-hanging top, formed at first by a cornice, later ovolo or thumb moulding. Later pieces occasionally with caddy top (i.e. inset with narrow moulding all
round). Tops often quarter-veneered (i.e. veneer laid in four identical pieces) until about 1710; thereafter one piece, usually with broad, cross-banded border.
Bun feet with simple plinth moulding until about 1710, then bracket. (Many have had their bun feet replaced with brackets at a later date. The original holes will still be visible in the carcase base.)
Drawer fronts flat, fashions for edge decoration and finish varying, some running concurrently:
Right, simple cross-banding, late 17thC; centre, feather cross-banding, early 18thC and below, allover veneer with inset stringing, late 17th C.
About 1680-1710: Simple cross-banding. About 1690-1720: Feather (or herringbone) cross-banding.
About 1690-1710: All-over veneer with inset stringing.
With these types, front of carcase between and around the drawers has a single or double half-round moulding.
About 1710-1720: Rebated ovolo lip moulding extending beyond edge of drawer, concealing gap between drawers and carcase.
About 1730 until late-19thC: Cockbead (i.e. a narrow and slightly projecting moulding rebated around drawer but not extending beyond edge).
With these types, drawer dividers plain.
THE BACHELOR’S CHEST
A popular variant, dating from about 17101740, and mostly made in walnut, though occasionally mahogany, is the bachelor’s chest. This is much shallower than average and characterized by a folding top, hinging down from the front and supported on lopers to provide a writing slide. Unusual and desirable, so fakes are not uncommon. Check that the drawer runners stop short of the back; if not, it is almost certainly made up from a cut-down standard chest.
A, plain bracket foot, late 18thC; B, William and    A turnip foot, early 18thC. Mary ban foot; C, flattened bun foot, late 17thC  veneered chest of about 1690.
Veneer: Predominantly walnut; occasionally mahogany after about 1720. Also yew, mulberry, sycamore and many other burr and figured woods. Laburnum, lignum vitae, king-wood, olive-wood and others used for
oyster veneers (i.e. veneers cut across the grain from small branches). Boxwood, holly, ebony, and other woods for inlay and marquetry, also occasionally bone.
Carcases: Pine for all veneered surfaces; oak for drawer linings (except the drawer front. On these a strip of oak often concealed the pine top edge). Oak or deal carcase when japanned.
Hand-cut veneers, at first thick (about 1/8 inch/3 mm), cut across the grain. Early through-dovetails on all parts originally covered by veneer; lapped dovetails from about 1690-1700. Sides of drawers narrower.
drawer construction, veneer hiding dovetails
Drawer linings rebated and glued into sides. Grain running front to back except on very large drawers, when side to side. Drawers with runners on underside, supported on bearers, often with solid dustboards too.
Drop handles attached by split-pin (or tang) method. Plate handles with bolts and circular nuts (fixed with special too]). Pine, sometimes oak, backboards nailed on.
REPLACED HANDLES
It has been estimated that approximately 90 per cent of all chests of drawers have had their handles replaced at least once. This will be obvious from the number and position of holes visible on the inside and probably
from filled holes on the outside. On veneered drawers, if the holes on front and back do not tie up, the piece has certainly been re-veneered, or even veneered for the first time (see below).
Principally geometric patterns of figured veneer. Inlay (often as stringing or circles or ovals), cross-banding. Much use of symmetrically arranged burr and oyster veneers.
Floral marquetry, about 1690-1720; usually contained within panels, not all over as on contemporary Dutch chests.
After about 1680 occasionally chinoiserie japanned decoration on black ground (survivals rare).
Handles: Iron (towards 1700 brass) drop handles. C-scroll bail handles with backplates from about 1700. Early backplates solid and shaped, with bevelled edges; sometimes incised. From about 1720 more often
pierced.
Largish centrally placed decorative lock escutcheons.
Varnish (diluted glue applied in layers and sanded down between applications) to fill the grain and produce a smooth surface, followed by wax polish.
Unfortunately many ‘antiques’ were French polished by the Victorians and have subsequently had to be re-polished, thereby losing their original finish and the mellow colours produced by patination.
VALUES
Prices invariably in four figures, many in five. Being particularly valuable  and rarely in totally original condition  false versions are not uncommon. Watch out for all-oak or all-pine construction. In both cases the chest probably started life without veneer; the first in the 17thC or 18thC, the latter in the late 19thC (although it could possibly be an imported Continental version). Look carefully at the construction of the drawers.
Carcase construction revealed.